Hello and welcome to another Wednesday update, I know it’s been nearly a month since I did an update, and even that update was a bit thin with content.

The Kitchen aka the excuse

So nothing to do with robotics but the main reason I have done very little in the way of tech. My entire kitchen, dining room, and downstairs bathroom have been replaced including removing a wall which resulted in a lot of work, a lot of mess, and a lot of noise. This basically stopped me from doing anything interesting as after I would finish work on a Wednesday I was cleaning, moving stuff, or helping the builders who were friends of mine. They did an epic job however I think I will be cleaning for a very long time. At the same time, I also had my windows replaced.

Inmoov Robot

So a month on and it’s hard to remember what I was doing, I have made some progress with the Inmoov Robot which is good. I have nearly finished the second arm however one of the main bottom supports (which connects the robot to the chair pole) is now damaged which is not good! This will be quite a lot of work to sort out however if I don’t, the robot is likely to fall over and smash.

Gwiz

Nothing really has happened with this, I still want to see if I can make it drive itself.

Electronics course

I have made a bit of progress on this and passed the second test (barely due to the gap between lessons). I hope to complete this by next week

Hosting for Burf.co

So after some social media feedback to HostPapa, a new member of staff has been trying to help me lower the concurrency issues with my site (Entry Points). I still find this a terrible way to do business (unlimited everything as long as it comes in single-file) as that’s not the way the internet works. I did actually check CPU and Memory usage and it was barely anything!